Appliance GuideNEC 2023 · Updated

LED Bulb (60W equivalent): Circuit and Wire Size

LED Bulb (60W equivalent) does not need its own circuit. It is wired onto an ordinary 15A or 20A lighting or general-purpose circuit, and the circuit’s breaker sets the wire: 14 AWG copper on 15A, 12 AWG copper on 20A (NEC 240.4(D)).
Circuit15A or 20A
DedicatedNo
Voltage120V
Watts8-12W

Specifications

ItemValue
Typical draw8-12W (0.1A)
CircuitExisting 15A or 20A lighting or general-purpose circuit
Wire on a 15A circuit14 AWG copper
Wire on a 20A circuit12 AWG copper
Dedicated circuitNot required

FAQ

Does a LED bulb (60W equivalent) need a dedicated circuit?

No. At 8-12 watts (0.1 amps) it is a small load. It runs on a 15A or 20A lighting circuit shared with other loads.

What wire size is on a circuit for a LED bulb (60W equivalent)?

14 AWG copper if the breaker is 15A, 12 AWG copper if it is 20A. NEC 240.4(D) does not allow 14 AWG on a 20A breaker.

Need the circuit itself? See 15 amp circuit wire size and 20 amp circuit wire size.

Requirements vary by state. NEC edition, licensing, permits, and GFCI rules differ by jurisdiction. Check your state or pick it below for personalized info across WireRef.
Important: For reference only. Not a substitute for a licensed electrician. Electrical work can cause serious injury, death, fire, or property damage if performed incorrectly. Always hire a licensed electrician for electrical work, especially for service upgrades, panel work, and 240V circuits. Values are derived from NFPA 70 (NEC) for educational purposes. Always verify against your locally adopted NEC edition and amendments - local jurisdictions may enforce stricter requirements. WireRef provides reference information only and is not responsible for work performed based on this content. NEC® is a registered trademark of the National Fire Protection Association. Free NEC access via NFPA · OSHA Electrical Safety · Terms of use.

NEC 2023 references verified February 2026 · Report a mistake