South Dakota Electrical Code & NEC Adoption
This guide covers everything you need to know about electrical code in South Dakota, including the current NEC edition (2023), wire sizing requirements, GFCI rules, electrician licensing, permit costs, and city-specific regulations. South Dakota scores 95/100 on WireRef's compliance scale, placing it in the strict tier for code enforcement and safety oversight.
How South Dakota scores on electrical code compliance
WireRef rates each state's electrical code environment on a 0-100 scale based on four factors: NEC edition recency, licensing requirements, permit enforcement, and active state amendments. South Dakota scores 95/100, rated Strict.
This score is for informational purposes only. A lower score does not mean electrical work in the state is unsafe - many local jurisdictions enforce strict standards independently of statewide policy.
Wire sizing requirements in South Dakota
The core ampacity values in NEC Table 310.16 have been unchanged since NEC 2017. Whether your South Dakota jurisdiction uses NEC 2017, 2020, 2023, or 2026, the wire sizing for residential circuits is identical. The table below covers the most common residential circuits:
| Circuit | Wire (Cu) | Breaker | Insulation |
|---|---|---|---|
| Kitchen 20A outlet Required for all kitchen receptacle circuits per NEC 210.11(C)(1) | 12 AWG | 20A | NM-B (Romex) |
| Bathroom 20A outlet Dedicated 20A circuit required per NEC 210.11(C)(3) | 12 AWG | 20A | NM-B (Romex) |
| General lighting 15A Standard for bedroom, living room, hallway lighting circuits | 14 AWG | 15A | NM-B (Romex) |
| Electric dryer 240V 10/3 NM-B for cable; 10 AWG THHN in conduit | 10 AWG | 30A | NM-B or THHN |
| Electric range 240V 6/3 NM-B for cable run; dedicated circuit required | 6 AWG | 50A | NM-B or THHN |
| EV charger (48A) 48A continuous load x 1.25 = 60A breaker minimum | 6 AWG | 60A | THHN in conduit |
| Central A/C (3-5 ton) Sized per unit nameplate MCA and MOCP values | 10-6 AWG | 30-50A | THHN |
| 200A dwelling service 2/0 copper or 4/0 aluminum per Table 310.15(B)(7) for dwelling services | 2/0 AWG | 200A | USE-2 or THHN |
For long wire runs in South Dakota (over 50 feet), voltage drop becomes the limiting factor before ampacity. Use our voltage drop calculator to verify your wire size keeps voltage drop under 3% for branch circuits or 5% total (feeder + branch).
GFCI requirements in South Dakota
Under NEC 2023 (enforced in South Dakota), GFCI protection is required in all kitchens - including the refrigerator outlet - plus all basements (finished and unfinished), laundry areas, and any area with a sink used for food preparation. This is significantly broader than prior editions.
| Location | GFCI requirement |
|---|---|
| Kitchen | All kitchen receptacles require GFCI regardless of location, height, or distance from sink. This includes the refrigerator outlet, which was previously exempt if more than 6 feet from the sink. Section 210.8(A)(6). |
| Bathroom | All bathroom receptacles require GFCI. This has been consistent since NEC 1975. Section 210.8(A)(1). |
| Outdoor | All outdoor receptacles require GFCI, including those not readily accessible. Receptacles at grade level must have in-use covers. Section 210.8(A)(3). |
| Garage | All garage receptacles require GFCI. Ceiling-mounted receptacles for garage door openers are included. Section 210.8(A)(2). |
| Basement | All basement receptacles require GFCI - both finished and unfinished areas. Previously only unfinished basements required GFCI. Section 210.8(A)(5). |
| Laundry | Laundry area receptacles within 6 feet of a sink require GFCI. The washer receptacle itself requires GFCI if within 6 feet of the laundry sink. Section 210.8(A)(10). |
See detailed GFCI rules by room: Kitchen · Bathroom · Garage · Outdoor · Basement · Laundry · Bedroom · Pool & Spa
What changed when South Dakota adopted NEC 2023
When South Dakota moved from NEC 2020 to NEC 2023, several rules changed that affect residential electrical work. Here are the key differences:
| Change | What it means |
|---|---|
| GFCI Requirements Expansion | Before: Kitchen GFCI required only for countertop receptacles (6-ft rule from sink) Now: ALL kitchen receptacles must be GFCI protected, plus hardwired appliances per 210.8(D) |
| General Lighting Loads Table Renumbering | Before: Table 220.12: Office = 1.5 VA/sqft (multiply by 1.25 for continuous) Now: Table 220.42(A): Office = 2.0 VA/sqft (already includes 1.25) |
| Dwelling Lighting Load Location | Before: Table 220.12: Dwelling = 3 VA/sqft, garages excluded Now: 220.14(J): Dwelling = 3 VA/sqft, garages INCLUDED |
| Box Fill EGC Counting | Changed in 2020 (not 2023): First 4 EGCs count as 1 conductor, each additional = 0.25. Pre-2020: ALL EGCs counted as 1 regardless of quantity. |
| EV Charging Article 625 | 2023 added emergency shutoff requirements, EVSE-specific receptacle configurations, and 5mA GFCI threshold for EV charging. |
Electrician licensing & permits in South Dakota
South Dakota requires electricians to be licensed. The primary license is the Electrical License, administered by the South Dakota Electrical Commission. Visit the South Dakota Electrical Commission website for application requirements and fees. Homeowners are generally exempt from licensing requirements when performing electrical work on their own primary residence - but permits and inspections are still required.
Verify a license: Check whether an electrician is properly licensed in South Dakota using the official license verification portal. Always verify before hiring.
Permits: Electrical permits are required for most new circuits, panel upgrades, and service changes. Homeowners may pull permits for their own primary residence in most jurisdictions.
Typical permit costs: Residential electrical permits in South Dakota generally range from $40-$150 depending on the scope of work and jurisdiction.
Permit costs are approximate and vary by jurisdiction. Contact your local building department for exact fees. Costs shown are for residential electrical permits and may not reflect commercial rates.
Common electrical projects that require a permit in most South Dakota jurisdictions:
- New circuits - adding any new branch circuit to the panel
- Panel upgrades - replacing or upsizing the main electrical panel
- Service changes - upgrading from 100A to 200A service
- EV charger installation - new 240V circuit for Level 2 charging
- Hot tub or pool wiring - Article 680 requirements apply
- Detached structure wiring - garage, shed, or ADU subpanel
Work that typically does not require a permit includes replacing switches, outlets, and light fixtures on existing circuits (no new wiring). However, rules vary - when in doubt, call your local South Dakota building department before starting.
License types in South Dakota
| License Type | Experience | Exam | Details |
|---|---|---|---|
| Apprentice Electrician | See requirements | No | Must register with Electrical Commission |
| Journeyman Electrician | 8,000 hours | Yes | 4 years apprenticeship or equivalent |
| Master Electrician | 10,000 hours | Yes | 1 year as Journeyman plus exam |
| Electrical Contractor | See requirements | Yes | Must employ Master Electrician |
Continuing education in South Dakota
South Dakota requires 8 hours of continuing education annually for license renewal. 8 hours annually. Must include NEC code update.
License reciprocity
Licensed in South Dakota? Your license may transfer to these states:
Reciprocity requirements vary. Contact the destination state's licensing board for exact transfer requirements. Some states require additional exams or documentation. See our reciprocity explorer for details.
Homeowner exemption: Yes. Homeowners may do electrical work on their own residence with permit
Major cities: building departments & local codes
While South Dakota's statewide code provides the baseline, individual cities may have additional requirements, different permit fees, or local amendments. Below are the building department contacts for South Dakota's largest cities.
| City | Building Department | Notes |
|---|---|---|
| Sioux Falls | Building Services | Follows state NEC adoption |
| Rapid City | Building Inspection | Follows state NEC adoption |
City-specific information last verified Apr 2026. Contact the building department directly for current fees and requirements. WireRef is not affiliated with any municipal building department.
EV charger permit requirements in South Dakota
Most jurisdictions in South Dakota require an electrical permit for Level 2 EV charger installation. A Level 2 charger typically requires a dedicated 240V circuit with a 50A or 60A breaker and 6 AWG copper wire (for a 48A charger at continuous load).
| Spec | Requirement |
|---|---|
| Typical circuit | 240V, 50A or 60A breaker, 6 AWG copper THHN |
| Permit required | Yes, in most jurisdictions |
| Continuous load rule | 48A charger x 1.25 = 60A breaker (NEC 210.20) |
| GFCI/disconnect | Disconnect within sight of charger per NEC 625. GFCI protection per NEC 625.54 (outdoor) or manufacturer requirements |
As an Amazon Associate we earn from qualifying purchases.
See our complete EV charger wiring guide for detailed installation requirements. For state incentives and rebates, check the DSIRE database for South Dakota-specific programs.
Frequently asked questions: South Dakota electrical code
What NEC edition does South Dakota currently use?
South Dakota currently enforces NEC 2023. It became effective on November 12, 2024. This determines the baseline electrical safety requirements for all new electrical work in the state. Local jurisdictions may adopt more recent editions or add amendments.
Do I need an electrician license to do electrical work in South Dakota?
Yes - South Dakota requires a Electrical License for professional electrical work through the South Dakota Electrical Commission. However, homeowners are generally exempt when working on their own primary residence.
Do I need a permit for electrical work in South Dakota?
Yes - most electrical work in South Dakota requires a permit, including new circuits, panel upgrades, and service changes. Typical residential permit costs range from $40-$150. Homeowners can typically pull permits for their own residence.
How much does an electrical permit cost in South Dakota?
Residential electrical permits in South Dakota typically cost $40-$150 depending on the scope of work and specific jurisdiction. Costs vary significantly between cities - contact your local building department for exact fees.
What wire size do I need for a 20-amp kitchen circuit in South Dakota?
12 AWG copper is required for all 20-amp circuits regardless of which NEC edition South Dakota enforces - the ampacity tables in Table 310.16 have been unchanged since NEC 2017. Use 12/2 NM-B (Romex) for standard cable runs or 12 AWG THHN in conduit. See our kitchen wiring guide for complete requirements.
Does South Dakota require GFCI in the kitchen?
Yes - under NEC 2023, all kitchen receptacles require GFCI protection, including the refrigerator outlet. This was expanded in NEC 2023 from the previous rule that only covered countertop outlets within 6 feet of the sink.
Do I need a permit for an EV charger in South Dakota?
Yes - most South Dakota jurisdictions require an electrical permit for Level 2 EV charger installation since it involves a new 240V circuit. The typical installation requires a 60A breaker with 6 AWG copper wire for a 48A charger. See our EV charger wiring guide for complete specs.
How do I verify an electrician's license in South Dakota?
You can verify any electrician's license status through the official South Dakota license verification portal. Always verify before hiring an electrician for your project. Ask for the license number upfront and confirm it is active and in good standing.
How does South Dakota's electrical code compare to other states?
South Dakota scores 95/100 (Strict) on WireRef's compliance scale. This places it among the strictest states, with a current NEC edition, mandatory licensing, and active permit enforcement.
Related guides
Compare South Dakota to other states
Head-to-head comparisons
All states
States are color-coded by NEC edition: 2023+ current, 2020 one cycle behind, older/local two+ cycles behind.
NEC 2023 references verified April 2026